2019 Range Rover

КРЫШКА БАГАЖНОГО ОТДЕЛЕНИЯ

WARNING

Medical devices: The undersides of the front and mid-loadspace cover sections each contain a magnet. The magnets are located in the recesses along the centreline of the vehicle. The magnetic field may interfere with pacemakers, defibrillators, or other medical devices.

When in the vehicle, or when handling the loadspace cover, maintain at least 15 cm of separation between the pacemaker or defibrillator and the loadspace cover.

WARNING

Never place objects on top of the loadspace cover. During an accident or sudden manoeuvre, loose objects can cause serious injury or death.

WARNING

Do not store the loadspace cover loose in the vehicle. During an accident or sudden manoeuvre, loose objects can cause serious injury or death.

To fold the loadspace cover:

  1. Push firmly down and forward. Then, push upward on the underside of the loadspace cover handle.

  2. Fold the loadspace cover forward.

NOTES

To remove or refit the loadspace cover, it is first necessary to make sure the rear seats are in the fully upright position.

To remove the loadspace cover:

  1. Pull the whole assembly rearward to disconnect the locating pins. Remove and store safely.

  2. To refit the loadspace cover, place the assembly in position. Engage the locating pins into the sockets and press firmly to lock the assembly in position. If required, pull the outer edge toward the rear to cover the loadspace area.

To access the loadspace from inside the vehicle: Push firmly down on the furthest edge of the cover while pulling it toward the rear seats. The cover folds, allowing access to the loadspace area.

NOTES

To access objects in the loadspace from within the vehicle, it may first be necessary to remove the rear head restraints.

Loadspace cover for executive class vehicles:

To fold the loadspace cover:

  1. Flip over the first board of the loadspace cover.

  2. Fold the remaining boards.

NOTES

To remove or refit the loadspace cover, it is first necessary to make sure the rear seats are in the fully upright position.

To remove the loadspace cover:

  1. Disconnect the two locating pins.

  2. Pull the whole assembly rearward. Remove and store safely.

To refit the loadspace cover, place the assembly in position. Engage the locating pins into the sockets and press firmly to lock the assembly in position. If required, pull the outer edge towards the rear to cover the loadspace area.