2019 Range Rover

СНЯТИЕ ЗАПАСНОГО КОЛЕСА

Make sure to read and fully understand the following warnings. Failure to comply with the safety instructions may result in an accident, leading to serious injury or death.

WARNING

Remove the spare wheel before jacking the vehicle, to avoid destabilising the vehicle when raised.

WARNING

Wheels are heavy and, if handled incorrectly, may cause injury. Use extreme caution when lifting, lowering, and manoeuvring the wheels.

WARNING

Do not store the wheel while the vehicle is raised on the jack.

WARNING

Always secure the spare wheel, or the removed wheel, in the correct position, using the securing bolt.

WARNING

After wheel changing, always secure the tools, jack, and the replaced wheel in the correct storage positions. Such objects, if not properly stored, can become flying missiles in a crash or rollover, potentially causing injury or death.

CAUTION

Always use the spare wheel's lift assist tool when removing the wheel. Avoid contact with the expansion chamber of the air supply unit, as it may result in damage to the compressor.

NOTES

Not all vehicles have a spare wheel's lift assist tool supplied as part of the tool kit. For more information, contact a retailer/authorised repairer.

NOTES

Before removing the spare wheel, take note of its storage position. The wheel to be changed must be correctly stored and secured in its place.

The spare wheel is located under the loadspace floor panel.

To remove the spare wheel:

  1. Open the tailgate. See ОТКРЫВАНИЕ И ЗАКРЫВАНИЕ ДВЕРИ БАГАЖНОГО ОТДЕЛЕНИЯ С ЭЛЕКТРОПРИВОДОМ.

  2. Raise and secure the loadspace floor panel.

  3. Continually rotate the centre clamp plate (1) on the spare wheel counter-clockwise to release.

  4. Continually rotate the top plate of the centre bolt (2) counter-clockwise to completely remove.

To remove the spare wheel on vehicles with a spare wheel's lift assist tool:

  1. Release the spare wheel as described above.

  2. Remove the spare wheel's lift assist tool. See НАБОР ИНСТРУМЕНТОВ.

  3. Attach the spare wheel's lift assist tool as shown.

  4. Pull the upper strap to lift up the spare wheel.

  5. Pull the lower strap to place the spare wheel on the tailgate.

  6. Remove the spare wheel's lift assist tool. Carefully lift the spare wheel from the vehicle.

NOTES

Reverse the order to store the changed wheel.