2017 Range Rover

ELECTRONIC AIR SUSPENSION CONTROLS

WARNING

Make sure that the vehicle is clear of people and obstacles before adjusting the suspension. Failure to do so can result in serious injury or death.

CAUTION

To maintain control of the vehicle at a standstill, during suspension height adjustment, make sure that the Electric Parking Brake (EPB) is applied. Also make sure that the transmission is engaged in Neutral (N) or Park (P).

CAUTION

Care should be taken with all suspension height changes, when a trailer is attached to the vehicle.

The electronic air suspension system is used to raise or lower the vehicle by adjusting the height of the suspension.

If safety permits, it is recommended that the engine is running during air suspension adjustments with the vehicle at a standstill. Doing so, allows operation of the vehicle's compressor to help maintain sufficient air reserves.

NOTES

Suspension adjustment slows and stops, if there is not sufficient air reserves in the electronic air suspension system. In this event, start the engine to allow operation of the compressor. Run the engine until sufficient air reserves resume.

NOTES

Frequent successive air suspension adjustments may deplete the vehicle's air reserves. In this event, allow time for the compressor to replenish the air reserves.

NOTES

Normal operation of the compressor generates heat. In the event of overheating, switch off the engine and allow time for the compressor to cool.

NOTES

The electronic air suspension system may raise or lower the vehicle automatically. For example, if a terrain response driving program requires it or if the vehicle is traveling at high speeds.

The electronic air suspension system controls are located on the center console. See DRIVER CONTROLS.

  1. Up button: Press and release to raise the suspension height. If a door is open, press and hold to raise the suspension height. The button’s LED indicator lamp illuminates during suspension height adjustment and extinguishes when complete.

  2. Down button: Press and release to lower the suspension height. If a door is open, press and hold to lower the suspension height. The button’s LED indicator lamp illuminates during suspension height adjustment and extinguishes when complete.

    NOTES

    The vehicle may not lower to the minimum height setting if a door is open.

  3. Off-road height indicator lamp: Illuminates when the suspension is set to off-road height.

  4. Normal height indicator lamp: Illuminates when the suspension is set to normal height.

  5. Access height indicator lamp: Illuminates when the suspension is set to access height.

    NOTES

    Access height is 2 in (50 mm) lower than normal height.

  6. Suspension locked in access height indicator lamp: Illuminates when the suspension is locked at access height.

  7. Access height button (driver's door): Press to set the suspension to access height.

Operation of the electronic air suspension system remains available for a few seconds after the ignition is switched off and the driver's door is opened.

The electronic air suspension system can also be remotely operated via the vehicle's smart key. See REAR HEIGHT ADJUST.