2017 Range Rover

FUSE BOX LOCATIONS

CAUTION

When a fuse box is exposed, take care to protect the box from moisture. Refit the access panel at the earliest opportunity.

  1. To access the loadspace fuse box, open the tailgate. Remove the right-side access panel, by grasping the top of the panel and pulling sharply.

    When refitting the access panel, make sure that the three securing pegs are aligned with their respective holes, before pushing the panel fully home.

  2. Loadspace fuse box. A label, located in a slot under the fuse box, shows the circuits protected and the fuse locations.

  3. To access the passenger compartment fuse box, open the glovebox. Press the top of the support stay at each end, and lower the glovebox into the footwell. A label on the front of the fuse access panel shows the circuits protected and the fuse locations. Remove the panel to gain access to the fuses. See STORAGE COMPARTMENTS.

  4. To access the engine compartment fuse box, remove the under-hood cover. See UNDER-HOOD COVERS REMOVAL.

  5. Lift up the edge of the leaf screen panel, just enough to allow removal of the fuse box cover.

  6. Remove the fuse box cover, by releasing the clips on each end. A label on the inside of the cover shows the circuits protected and the fuse locations.

Loadspace fuse box access: Vehicle's with a deployable loadspace floor :

To access the loadspace fuse box on vehicles fitted with a deployable loadspace floor:

Pull on the handle and slide the loadspace floor outward slightly.

Lift the leading edge of the loadspace floor and support with the strut.

Turn the two fixings on the right-side floor rail through 90°, to release from the spring clip. When released, turn through 90° again, back to the vertical position. Remove from the rail and keep in a safe place.

  1. Lift the removable rail section and carefully remove the rail from the vehicle.

  2. Support the floor and lower the strut. Lower the floor.

  3. Slide the floor fully outward.

  4. Remove the right-side access panel. See steps (1) and (2) at the beginning of this section.

    CAUTION

    When removing or replacing the access panel, take care to avoid damaging the panel on the floor rail.

After replacing the right-side access panel, slide the loadspace floor fully into the vehicle, until it engages.

Pull on the handle and slide the loadspace floor outward slightly.

Lift the loadspace floor up by its leading edge and support with the strut.

To replace the floor rail section, slide the rail back into position and align the fixing holes.

Hold the fixings in the vertical position and firmly push into the rail section. A click is heard as they engage with the spring clip.

Support the loadspace floor and lower the strut. Lower the loadspace floor.

Push the loadspace floor fully home, until it engages.