2017 Range Rover



The driver must always make sure that a safe speed is maintained within the speed limit, taking account of traffic and road conditions.

In certain conditions, such as a steep downhill gradient, the vehicle speed may exceed the set cruising speed. Driver intervention may be required as engine braking is unable to maintain or reduce the vehicle speed.


Do not use cruise control in heavy traffic, or conditions where a constant road speed cannot be safely maintained, such as on roads that are winding, wet with rain or snow, slippery or unpaved.


Cruise control is not available when using Hill Descent Control (HDC) or when the sand, mud-ruts or rock crawl terrain response programs are selected.


Do not use cruise control when driving off-road.

  1. SET+.

  2. RES.

  3. -

  4. CANCEL.

Cruise control allows the vehicle to automatically maintain a set vehicle speed. The system is operated by controls mounted on the steering wheel. The driver can also intervene at any time, by using the brake or accelerator pedals.

While driving at the desired speed, press the SET+ button to activate cruise control. An information lamp is displayed in the instrument panel to confirm that the system is operational. See CRUISE CONTROL (GREEN).


Cruise control can only be activated at speeds above 20 mph (32 km/h).

To increase the set speed, press the SET+ button. A single press of the button raises the vehicle speed by 1 mph (2 km/h). The set speed can also be increased by pressing the accelerator pedal. When the new desired speed is reached, press the SET+ button.


Cruise control is canceled if the accelerator pedal is pressed to override the system for more than 5 minutes.

Press the - button to lower the set speed. A single press of the button lowers the vehicle speed by 1 mph (2 km/h).

Press the CANCEL button to cancel cruise control. The set speed will be retained in the system's memory until the vehicle's ignition is switched off.

Press the RES button to resume the set speed from the systems memory.


The RES button should only be used if the driver is aware of the set speed and intends to return to it.

Cruise control is also canceled if:

  • The brake pedal is pressed.

  • The gear selector is moved to Neutral (N) or Reverse (R).

  • HDC or dynamic mode are activated.

  • The Electric Parking Brake (EPB) is applied.