2016 Discovery Sport

PROGRESS CONTROL SYSTEM SETTINGS

When the Progress control system is enabled, the desired target (set) speed for the vehicle can be set and adjusted via the control buttons, mounted on the right side of the steering wheel. See HILL DESCENT CONTROL (HDC) OVERVIEW.

  • SET+: While the vehicle is moving, press to enable the Progress control system, to recognise that the desired target vehicle speed is to be set and adjusted. Press repeatedly (or press and hold) to increase the target speed, up to a maximum speed of 18.6 mph (30 km/h). Alternatively, while making progress, press the SET+ button for the vehicle's current speed to be the set speed.

    NOTES

    If the vehicle is at a standstill, press and hold the brake pedal while using the SET+ button.

    NOTES

    Light and gentle application of the accelerator pedal will temporarily override the current set target speed. When the accelerator pedal is fully released, the Progress control system will revert back to the previously selected target speed.

    NOTES

    Dependent on the vehicle's specification, the set speed will either be displayed as a marker on the speedometer or displayed in the Message center.

  • (-): Press repeatedly (or press and hold) to decrease the desired target vehicle speed, down to the minimum feature speed of 1.1 mph (1.8 km/h).

    NOTES

    Light and gentle application of the brake pedal will also lower the target vehicle speed. When the brake pedal is fully released, the Progress control system will maintain the speed at which the brake pedal was released. If the brake pedal is pressed when the Progress control system is active, then a slight pulsation movement might be felt through the brake pedal.

  • CAN: Press to put the Progress control system into descent control mode. See USING THE PROGRESS CONTROL SYSTEM.

  • RES: Press to resume the set speed, if the target vehicle speed has been lowered by gently applying the brake pedal.

    CAUTION

    RES should only be used if the driver is aware of the set speed and intends to return to it.

When the vehicle is traveling at speeds between 18.6 mph (30 km/h) and 50 mph (80 km/h), the Progress control operation will be suspended, the system will enter into a standby mode and the Progress control warning lamp will flash. The Progress control system will resume operation if the vehicle's speed then becomes less than 18.6 mph (30 km/h) but does not exceed 50 mph (80 km/h). If the vehicle’s speed does exceed 50 mph (80 km/h), the Progress control system will be disabled and the warning lamp will extinguish. If required, the system will have to be switched on again.